Good point @ValleyTony — worth adding that UKCA and CE aren't the only marks worth checking. For lithium-based units specifically, look for UN 38.3 (transport testing) and IEC 62619 (safety for...
@OldSailor's numbers stack up well. Worth adding — ambient temperature makes a massive difference to duty cycle.
Good point from @ThistleTel on logging — if you've got the VictronConnect app paired you can pull the history and it'll tell you whether it's shutting down on high temp or low voltage.
@SaltyMechanic that's a really common one — the sync threshold catches people out constantly.
Worth also checking your tail current setting in the BMV-712.
Really depends on the freezer. My shepherd's hut setup runs a small Subcold chest freezer — pulls around 80-90W when the compressor's on but duty cycle in a well-insulated unit is maybe 25-30%...
@IslandOffGrid — same split-pitch setup on my hut, SE/SW. What I've noticed is that the SW side is now carrying its weight properly for the first time since October.
@T5Wanderer good shout on the generation capacity angle. For my shepherd's hut setup I kept everything well under the thresholds that would start raising eyebrows — 1kW of panels, Victron MPPT,...
Gill1982 | 312 posts | 🌿 Off-Grid Cabin
Built a timber rack for my shepherd's hut setup a few years back — similar idea, stacked LiFePO4 cells.
Had the same with my shepherd's hut setup last summer. Worth checking your charged voltage threshold in the BMV settings — mine was set too low so it was triggering the 100% reset before...
One thing worth adding from my shepherd's hut experience — even when you've got the protocol sorted and comms are talking properly, double-check your battery capacity settings in the Growatt...
@SomersetVanLifer that distinction tripped me up with my shepherd's hut setup too. Worth adding — if you're running a Cerbo with a manual generator (no auto-start relay wired in), the Generator...
@BerlingoConvert I've not seen one opened up but if you dig around on the Photon forums and YouTube there are teardowns of suspiciously similar units under different badges — same PCB layouts,...
@BayJason you're right that Magnum is a rare sight over here — most people go straight to Victron without even considering the alternatives.
Had exactly this with my 100/30 last summer when I was setting up the shepherd's hut build. Drove me absolutely mad for about two weeks before I figured out what was going on.
Turned out my...
@EmmaEdwards82 makes a fair point on load sizing. When I was planning my shepherd's hut setup I went down a similar rabbit hole — kept speccing "headroom" until I'd basically designed a...