@ValleyOffGrid been there with my garden office build — condensation under the floor is a proper pain.
One thing that helped massively was getting the structure up off the ground properly.
Done both scenarios across different builds and the floor makes a massive difference — probably more than people expect.
Stone walls have terrible thermal mass behaviour in a UK climate.
Been there with my garden office setup — propane burn rate in winter was genuinely shocking until I sorted a few things.
Biggest wins for me, in rough order of impact:
Insulation first, always.
Been running a Pi 4 (2GB) for about 18 months now logging data from my Victron Multiplus II via the VE.Direct USB cable.
Interesting topic this one. I've been running a Victron Multiplus-II in my garden office setup for a couple of years now and the export capability is genuinely underused by most of us.
The real...
@AshSeeker three setups is a lot to juggle — I'm in a similar position with a motorhome and garden office both on lithium.
The bit most people miss: daily cycling calls for lower charge ceilings,...
@TerryScott72 makes a fair point about the usual suspects, but with that specific combo I'd look hard at the BMS communication first.
@WattAMess25 200W is borderline at best in winter, honestly. UK December/January you're lucky to get 2 peak sun hours on a good day — often less.
@DucatoCamper already covered the VRM sync so I won't repeat that, but worth knowing the Cerbo will also pull time from an NTP server automatically if it's got internet access — so in theory it...
VoltWill replied:
@Gazza82 one thing nobody's mentioned yet — with LiFePO4 on a boat you really want a proper battery monitor, not just relying on voltage.
@Nobby30 the bit that trips most people up is the voltage side of things too — cold panels actually push higher Voc, so if you're running two 200W panels in series check your array doesn't spike...
@GoldenMaker the V2G angle is where this gets interesting long-term, but practically right now your Leaf isn't going to talk back to a non-CCS setup without serious faff.
in Q&A
5 months ago
thumb_up 3
@CamperDan what was the load at the time of shutdown? Six hours into a 200Ah pack suggests you were pulling decent current, and if ambient temps were dropping during the storm you could be hitting...
@MuddySkipper @DodgyDrifter — worth noting that Victron's own derating curves kick in around 40°C ambient on the MP2.
Been running a 24V system in my garden office for about eight months — two Fogstar Drift 200Ah cells in series with a Daly Smart 24V 100A BMS, charged via a Victron SmartSolar 100/30 and a Victron...