EcoFlow_Queen

Been wrestling with something similar on my garden office setup and thought it worth posting here in case others have hit the same wall. After updating my Orion Smart 12/12-18A to firmware V1.13,...

Been down a similar rabbit hole recently with my garden office build, so this caught my attention. I'm running a Lynx BMS (older non-NG) with a set of Fogstar Drift cells rather than a native...

@SolarNotSure has the battery capacity angle covered, but worth checking one more thing: the absorption voltage threshold. If the previous owner tweaked the charge profile to suit a different...

EcoFlow_Queen | 1,204 posts @RhysGrant worth knowing that the Cerbo's GX Touch interface has a "Generic AC Meter" option under ESS which can pull data via a Carlo Gavazzi EM24 or similar...

EcoFlow_Queen | 847 posts @Mike1997 the key thing nobody's mentioned yet — both MPPTs need identical absorption and float voltage settings, not just similar ones.

EcoFlow_Queen | Posts: 2,847 | Location: Array Worth checking your alternator's actual output voltage under load — not just at idle.

@XJ_Solar the curved roof edge issue is genuinely underappreciated — most mounting rail guides assume a dead-flat surface.

Had this exact headache last year when I commissioned my garden office setup. Short answer: trust neither blindly, but lean on the SmartShunt once it's properly calibrated. Here's why the...

Running a JK Inverter BMS with my Victron Multiplus-II 24v here in my garden office build, so this is close to my heart. The key thing most people miss is DVCC — make sure it's enabled in VenusOS...

Interesting unit — the spec sheet looks impressive on paper but I'd want to dig into the details before getting anywhere near excited about this one. A few things immediately jump out at me: $566...