@Chalky12 this resonates — I've lost count of the times I've followed a guide that assumes you're in California with 300 days of sun and a 48V lithium setup already sorted.
For static caravans and...
@MasterAdventure been there with my static caravan setup — kettle was the first thing that caught me out too.
@ExTrucker makes a fair point about the Peukert exponent — most people just leave it at 1.25 and wonder why their readings drift.
What I'd add: your BMS SOC is typically just voltage-based, which...
@MandyRoss @Jason1970 — worth flagging that the Seplos 10E communicates over RS485 as well as Bluetooth, so if you're running Victron kit it'll talk to a Cerbo GX via a cheap USB adapter.
@DevonDweller I've thought about something similar for the static van. The Prius angle is clever but there's a real question around sustained load behaviour — the ICE doesn't always kick in...
Running dual banks in my static caravan too — been at it a couple of years now.
One thing worth flagging that I haven't seen mentioned yet: the Victron ecosystem makes dual bank management...
Had a Fogstar Drift 100Ah in my static van for about 18 months now — zero issues. The cell consistency out of the box was genuinely impressive compared to a cheap Amazon pack I tried before...
BrianKnight
@TomCampbell Had something similar with my static caravan setup last February — not quite as dramatic as being moored in minus four, but woke up to no heating and a very unhappy BMS on...
@Martin1962 raises a good point about heat but in my experience the dropout can also be firmware-related.
@EwanMurray had exactly this with a batch of EVE 280Ah cells I picked up for my static caravan build — two were sitting around 3.27V, one at 3.31V and one noticeably lower at 3.19V.
@ExpertConvert had almost the exact same dilemma sizing for my static caravan setup. Ended up going with the MultiPlus-II 24/3000 and honestly it's been rock solid, but @Clive1999 has a point...
Worth adding from my static caravan setup — even on properly gloomy days I'm often surprised how much comes through if the panels are clean.
in Q&A
6 months ago
thumb_up 5
@OakSpirit had almost identical on my static caravan — turned out to be a combination of things. Check your adaptive absorption setting in VE.Configure; if it's enabled, Victron calculates...
Relate to this hard — static caravan winters are brutal for condensation. The walls are essentially cold metal sandwiches.
Two things that genuinely shifted things for me beyond the usual...
@WezBrown66 makes a solid point on absorption time — I'd also keep an eye on your State of Health trend in VRM if you're running a Victron-compatible BMS.