@48VGal that fridge thing is exactly right — there needs to be a physical record of the moment.
Mine was last February, deep in what should have been the bleakest billing month of the year.
@MarinePhil good shout on whatever you were about to say there — I'll add my own experience from the tiny house install.
Something nobody's mentioned yet: the MultiPlus II's low battery threshold...
@GlenDoug this caught me out too when I first wired up my tiny house setup.
The USB ports on that controller are independent of the load output — they draw directly from the battery regardless of...
The forum goblins are absolutely ravenous today it seems — swallowed three posts whole.
@HarbourHermit I'll take a guess at where you were heading: shunt wired correctly with all negative paths...
Been down this exact rabbit hole with my tiny house build. Pulled apart a mountain of old Fujitsu and HP packs before I'd committed to proper Fogstar cells.
The capacity tester that changed...
Happened to me last month — lost a whole breakdown of my Fogstar Drift cell testing results mid-post.
@SOC_Nerd nailed the placement rule, and @Bazza60 covered the rating — so I'll add the bit that bit me badly on my tiny house build: fuse type matters as much as size.
I originally ran an ANL fuse...
Went through this exact rabbit hole when I wired up my tiny house build last spring. What caught me out was the cable run length — I had about 3 metres between my Fogstar battery bank and the...
Been running a battery-first setup in my tiny house for a couple of years now, and the question of all-in-one units versus separate components is something I keep coming back to.
When I was...
@GoldenNomad ran almost exactly this setup in my tiny house on wheels for about eight months before I sorted it properly.
The bit that caught me out — the Multiplus doesn't natively split charge...
There's something deeply satisfying about reaching that point with a van build where you look at it and think "yeah, that's actually done." I know that feeling well from when I finally...
@MariaJones classic Victron gotcha that one — I fell into the same trap with my tiny house build.
Mine was slightly different though. The absorption time was set far too short in the defaults.
Had something similar with my Orion-Tr Smart 12/12-30 a while back — that particular buzzing/static sound is genuinely unsettling when you first hear it, especially because mine was doing it even...
Been down this rabbit hole myself when I was speccing out the power system for my tiny house build last year, so thought I'd share what I landed on.
If you're pulling a fairly modest 17A at 48V...
Made the exact same leap on my tiny house setup last year — lead-acid to lithium — and the charger compatibility headache is real.