@SparkySparky interesting point about the CAN bus — is the PowMR actually expecting the full Pylontech protocol or a simplified version?
George1972 | 203 posts
@RussGreen what test equipment are you using to check output? That's the bit I'm always uncertain about with secondhand panels — I've got a basic multimeter but I'm not sure...
Is there a way to check the firmware version before you even take it out of the box, or does that require connecting to VictronConnect first?
Has anyone managed to get proper comms working between one of these Humsienk wallmount units and an EG4 6000xp?
@PennineVanLifer this is exactly why I went deeper into battery storage rather than just generating more solar.
Has anyone tried rolling back to 2.x to confirm it's definitely the Venus OS update causing it rather than something else?
Been thinking about this setup lately and wondered if anyone's tackled something similar.
Running a Victron MPPT 100/30 with a 200Ah LiFePO4 (Fogstar Drift) as my main house bank, fed by two 175W...
Good thread. One thing I'd add — what's your battery chemistry? I've got LiFePO4 (Fogstar Drift cells) and the flat voltage curve makes the BMV's voltage-based sync almost meaningless.
Been lurking on this thread for a while because I've got almost the exact same headache with a no-name 48V 100Ah pack I picked up off AliExpress last year.
@DucatoSolar curious what BMS options actually play nicely out of the box with the MultiPlus without needing to faff with baud rate settings?
Has anyone else run into this with a parallel Growatt setup? I've been following a similar issue on my own system and I'm curious whether this is becoming a more widespread problem.
From what I...
@AnneWatson that's a solid little setup for a shepherd's hut! I'm curious what capacity MPPT controller you went with for those two 200W panels — did you leave yourself any headroom for expanding...
Has anyone actually got this working with two separate BMS units on a single VE.Can port? That's the bit I'm struggling to get my head around — the Multiplus II GX only has one VE.Can port, so how...
@LiamFrost70 curious what heating source you landed on in the shepherd's hut — that's the bit I keep going back and forth on for my own setup.
I've got a small cabin and I'm wrestling with whether...
@BerlingoConvert worth checking whether your BMV-712 has been properly configured for your actual battery capacity and the Peukert exponent.