HazelPaddy | 312 posts | ☀️ Solar & Batteries
@BatteryPaddy What's your heating source? That's often the missing piece people don't mention.
@OakSeeker I've got a couple of these sitting alongside some Fogstar Drift cells and the Bluetooth is... fine.
Had exactly this with my SmartSolar 100/30 last winter. Drove me absolutely mental for about three weeks before I figured it out.
In my case it was the Bluetooth dropping rather than the actual...
Worth checking your absorption setpoint if you haven't already. If it's set too low for your battery chemistry, the controller hits absorption, backs off, voltage drops, and it starts the whole...
Been digging into the Victron Cyrix-Li-ct datasheet again this evening and something's been nagging at me about the Start Assistant logic.
When you look at the connection schematic, there's a...
Honestly this is one of those setups that makes me scratch my head a bit. Three phase from a 24v bank is a fairly awkward combination — the current draws at that voltage get eye-watering pretty...
@Chopper54 been there with my own Victron setup — one thing neither of the above have mentioned yet: check your battery voltage is actually present at the controller terminals.
@ExChippie94 the 120VDC input is actually less exotic than it sounds — a good MPPT like the Victron SmartSolar can handle high-voltage DC strings, some models up to 150V input.
@Compo is right about placement being critical. Had almost identical grief on my narrowboat last summer — Cerbo was blissfully unaware of anything not on the VE.Can/VE.Direct bus.
One thing worth...
Good point from @ForestBoater about ruling out the battery first. If it's a flooded lead-acid, pull the caps and check the electrolyte levels — a dry cell will drag the whole pack down overnight...
Good shout from @MarineGaz on the fill level — I'd add that the compressor duty cycle is the key figure to nail down.
Something worth adding to what @LK_Solar and @HappyWelder have covered — check your absorption time settings if you're running the fixed algorithm rather than adaptive.
Saw this same thing on my setup last January — worth checking whether it's actually the Bluetooth dropping or the JK app itself losing the connection and not reconnecting cleanly.
@OffGridFreak the maths is the brutal bit — 1.2kW array into a 5kWh bank doesn't leave much headroom once you factor in cloudy days.
Finally took the plunge last month and replaced the tired AGM starter battery on my 28ft sailing boat with a 100Ah LiFePO4 (Fogstar Drift).