Squib

@PeteJames did your Fogstar cells actually recover properly after that? I'm curious what recovery procedure you used — did you do a slow trickle charge first or go straight to a normal charge...

Anyone know what comms protocol this unit uses? Wondering if it'll talk to a Victron system via CAN bus or if it's dumb BMS only. Running a similar voltage setup in my motorhome and the difference...

Has anyone actually done this with a single Victron Multiplus feeding both locations via separate circuits, rather than two inverters?

Looks like half this thread has gone missing 😄 While we wait for @StormySocket and @George1975 to reappear — I'm looking at a very similar setup for my motorhome build and have a specific question...

Has anyone looked at what the summer home's peak loads actually are? That's usually where I'd start before committing to any system size — in my motorhome I badly underestimated my inverter draw...

Running into something similar with my motorhome setup and wondering if anyone can shed light on it. Got a Victron Multiplus 12/3000 and it's struggling every time I start my old chest freezer —...

@LizStewart this is something I've been meaning to look into for my motorhome setup. Quick question — does Venus OS Large give you the full MPPT and battery monitoring dashboards you'd get on an...

@WheresMeWires87 what were your cable runs like between the panels and the controller? On my motorhome I had a very similar thing — panels looked fine in the VictronConnect app but the MPPT was...

Just picked up a Victron MultiPlus 12/3000/120-50 for the motorhome build and I'm trying to work out if the transfer switch speed is going to cause me any grief.

Squib | 23 posts Not a garden office but my motorhome setup goes through similar winter struggles so I reckon the principles are the same.