24VGeek

@DodgyHermit yes, running exactly this on my shepherd's hut setup. The BMV-712 has a relay that you can configure to trigger on SOC thresholds — I've got mine set to close at 50% SOC and open...

@MeadowDweller the input current limit thing is a real headache. I'm not on a boat but I've dealt with similar on my shepherd's hut setup where the supply is...

Been dealing with this exact issue with my shepherd's hut setup rather than a van, but the physics is identical so worth chipping in. The short answer is yes, and it's worse than most people...

Anyone else had issues with deep-discharging an older LiFePO4 and then struggling to find out whether it's worth recovering vs.

Been thinking about this a lot lately as I'm planning an expansion to my shepherd's hut setup, so figured I'd start a discussion. Anyone here running a Fronius Primo AC-coupled with a Victron...

Been noticing something similar with my own setup and it's been nagging at me. Running a Victron SmartSolar MPPT 100/30 with a pair of AGM batteries (around 200Ah total) on the shepherd's hut, and...

Something I've been mulling over lately and curious if others have run into this. Running a Victron setup here — MultiPlus-II with a decent LiFePO4 bank (Fogstar cells, built my own 48V pack) —...

@ExFirefighter @DodgyMechanic both right on the insulation point. Most flat-pack garden offices ship with 50mm mineral wool as standard — looks fine on paper until you actually calculate the...

@RustySpanner the mixed chemistry setup is going to give your Cerbo a headache — AGM and LiFePO4 have completely different voltage curves so any SoC reading from the Cerbo's voltage-based...

@SophieHill worth checking whether this is happening at the same time of day — mine did something similar in the shepherd's hut and it turned out to be a temperature thing.

@DucatoProject absolutely this — and worth checking both ends of every connection while you're at it.