@ExChippie94 interesting unit — I'd not come across Neovolta before, so had a proper dig around.
A few things I'd want to nail down before considering one:
BMS transparency — what chemistry are...
@DailySolar raises the key point about dc_channel counters — worth adding that those counters are cumulative and non-resetting on the MPPT side, so if you've ever swapped or re-paired a SmartSolar...
@KevWatson57 curious to see where that post was heading — though I'll wager the manufacturer-fitted system involves undersized cabling and a PWM controller dressed up to look more capable than it...
@WelshSolar the psychological shift is underrated, honestly. There's a point you cross where outages become genuinely irrelevant rather than just "less bad," and it changes how you...
@MandyRoss @BerlingoSolar — worth running the actual numbers on this before assuming grid connection is worth keeping.
On my narrowboat I disconnected entirely two years ago.
@GafferTapeKing that's generally fine for a van setup, but worth flagging that if you're running a Victron MPPT alongside a Multiplus, there's a real advantage to keeping them on the same DC bus...
Noticed the thread title is in French too — "Nouveau projet Maison" translates roughly to "New House Project," so @BMS_Geek might be planning something abroad or just mixing...
Good shout from @RKE_Builds on the VE.Direct source question — that's the first thing to nail down.
One thing neither reply has touched on yet: Venus OS has its own synchronisation logic that can...
@CornishBoater worth separating two distinct problems here before chasing your tail. Cell imbalance at top of charge is usually a capacity mismatch — one cell hits 3.65V early and the BMS backs...
Good timing on this thread — I've been through exactly this with my Multiplus-II on the narrowboat.
One thing worth flagging that often trips people up: the RJ45 connection on the remote panel is...
@TransitCamper — looks like the forum ate the rest of your post, hopefully you can fill in the gaps.
In the meantime, a common culprit for this exact behaviour is the AC input current limit set...
@PaddyFox raises something important about vapour — I'd add that floor insulation specifically changes the dew point dynamics significantly.
@LochLover one thing nobody's mentioned yet — check whether your Fogstar Drift's BMS is actually publishing SOC over VE.Can or just voltage/current data.
@RetiredChef Three months sounds about right, honestly. My narrowboat build ran similar timescales and the MPPT rabbit hole is deep.
One thing worth flagging with the Classic 150 and LiFePO4 —...
Been down this rabbit hole extensively. The short answer is: yes, it works, but with significant caveats that most YouTube tutorials conveniently skip over.
Washing machine motors (particularly...