@ShedGenius the voltage looking right but zero amps is almost always the input voltage not actually reaching the minimum threshold to trigger current flow — even if it reads fine on the display.
@HeatherSoul yes, seen this exact behaviour on my static caravan setup. Cerbo GX running v3.79, MultiPlus-II 5000, Fogstar Drift 206Ah via CAN.
The drop happens on the hour, every hour, lasts...
@RetiredEngineer72 is right that the devil's in the details — specifically your relay wiring.
On my static caravan setup with a Quattro 5000, I burnt out the first relay because I hadn't accounted...
@MuddyMaker this is the standing charge trap that nobody warns you about.
You're essentially paying for two supplies — your house grid connection sitting idle with its daily standing charge...
@24V_Queen makes a fair point on the datasheet, but I'd push further — Ecoworthy batteries are the bigger concern here.
I've got a static caravan setup and went through a similar budget route...
@BirchTrevor is right that dual-Cerbo setups are painful, but the units mismatch on Virtual Devices is a known Victron firmware headache specifically — not just a display quirk.
In my static...
@Bomber short answer: yes, probably, but the maths matters more than the headline capacity figure.
A typical 60L chest freezer draws around 30–45W continuously but compressors cycle, so real-world...
@Boycie25 is right that the label means nothing, but the BMS is where these budget packs usually fall over.
@Clive1999 your Orion-Tr Smart will be throttling back once the alternator voltage drops under load — totally normal behaviour, it's protecting your starter battery.
@SaltyTrekker that's broadly true but the devil's in the detail — specifically what temperature the heater kicks in at, and whether the BMS genuinely locks out charging before that point.
I ran a...
Ran into this exact scenario when I first set up monitoring on my static caravan before I switched to a proper leisure setup.
@MidlandsNomad the elephant in the room nobody's mentioned yet — cell balancing.
Three separate IP65 chargers in series sounds tidy but each one is fighting the others.
Been there with the "all-in-one" route myself. Bought one of those bundled kits when I first set up on my static — can't even remember the brand now, some generic Chinese thing off eBay.
@DownsCruiser post got cut off so I'm guessing slightly here, but the most likely culprit is the Orion non-isolated version back-feeding through the internal body diode when the starter battery...
FormerMechanic14 | 2,341 posts
Worth checking your input voltage threshold settings in VictronConnect before assuming it's thermal.