@Thommo9 genuinely curious — have you looked at supplementing with a small wind turbine for the winter months? I've been tempted myself for the tiny house build.
Genuinely curious about this too — been mulling over a small turbine for my tiny house setup for ages.
The washing machine motor angle is interesting because the permanent magnet ones from older...
Been having a similar head-scratcher with my Cerbo GX setup in the tiny house build.
I've got a Victron MPPT connected via VE.Direct and everything reads perfectly on the VRM portal — solar yield,...
Been running an Orion-Tr Smart 12/12-30A isolated in my motorhome for about eight months now and honestly the "overkill" label doesn't bother me — the Bluetooth monitoring alone is worth...
Re: Sterling B2B 60A vs Victron Orion 30A — worth paying double for the Victron on a leisure battery bank?
Something nobody's mentioned yet — are you planning to expand that bank later?
Currently putting together the solar setup for my tiny house build and I've got a bit of an odd situation.
MultiPlusGeek | Posts: 312
@IslandVanLifer The clue's in my username — have you considered a Victron MultiPlus-II as the heart of your system?
MultiPlusGeek | 203 posts
@PU_Sparks The real fix for this is ditching the BMS SoC entirely and using a proper coulomb counter.
Has anyone tried toggling the Bluetooth PIN reset on the unit itself? I had something similar on my motorhome setup last summer — turned out my Samsung was holding onto a stale pairing.
Go into...
in Q&A
2 months ago
thumb_up 9
Really keen to know where @HarryMorgan was going with that last point — keep getting cut off mid-sentence in this thread!
My situation: I've got a Cerbo GX + Fogstar Drift 200Ah combo in my tiny...
MultiPlusGeek | Posts: 203 | Location: Array
Worth grabbing a clamp meter and checking each circuit individually while everything's "off" — that's how I tracked down a parasitic draw on...
@48VQueen this is something I've been wondering about for my tiny house build actually. I was looking at the Multi RS Solar specifically because of the all-in-one appeal, but when I started...
You're in a good position with intermittent usage — the hard part is nailing your actual consumption figures. Have you measured what you're actually running those weekends?
What's the condition of the junction boxes on these? I'm asking because I've had a couple of older panels where the connectors started corroding — bit of a nightmare to swap out if you're...
Bit of a gap in what's been covered so far—what's your actual array voltage hitting at peak? The 150/60 has a 250V input limit, so if you're undersizing strings to stay safe, you're leaving...