@JackShaw yeah that's the VE.Smart Networking doing its thing — one unit gets elected as the "master" and coordinates charge state across all three.
@OffGridMax yeah doing almost the same on my tiny house setup. Pi Zero 2W actually — massively overkill for just MQTT → InfluxDB → Grafana but it barely sips power which matters when you're...
PanelMatt | Posts: 847 | Location: Array
Fogstar Drift is where I'd be looking if I were doing a motorhome build right now.
Been digging into this recently for my tiny house setup and thought it worth raising here.
So I've got a Victron MultiPlus handling most things, but I know a fair few people on here are running...
@RussGreen had this on my tiny house setup a few months back, different firmware but same symptoms — capacity readings all over the shop.
Worth checking if your cell voltage calibration got reset...
Seen something similar with my tiny house setup. DESS can be a bit stubborn when the cells are genuinely out of balance — it won't just reset the flag because time's passed, it needs to actually...
Had this exact issue last summer with my 100/20. Drove me mad for weeks.
Turned out my battery voltage sensing was the culprit — I had quite a long cable run between the MPPT and the battery bank,...
Yes, absolutely top balance first — don't skip it, you'll regret it.
When I got my first batch of Fogstar cells I was impatient and just chucked them straight in.
Got the Multi RS Solar running in my tiny house setup — cracking bit of kit.
Few things worth knowing:
Generator input is AC-in but the Multi RS Solar is not the same as the Quattro — it only has...
Been running a Pi 4 for about 18 months now on my tiny house setup and honestly wouldn't go back. Paired it with a Victron MPPT and the VE.Direct cable — once you've got Venus OS running it's dead...
Boats and garden offices do share a lot of DNA honestly. Main difference I've found is the marine environment absolutely brutalises connections — corrosion on terminals you'd never see in a dry...
Had the exact same bother with mine last year. Turned out the Orion was going into thermal protection on longer runs — the unit gets proper toasty if it's mounted somewhere with no airflow.
Few...
@HollyGaz is onto something — if the cable run isn't too long it's genuinely the simpler option. I've got a similar setup on mine and just ran a decent 16mm² cable between the two.
Got a Hobbit in my tiny house too — brilliant little stove for the size.
One thing I'd flag that nobody's touched on yet: ceiling height matters for the flue route.
PanelMatt | 312 posts
@CliveKnight Welsh weather is brutal on panels but honestly ground mounts are better for maintenance anyway — you can actually reach them to clean off the inevitable sheep...