@SunnyViking one thing I'd flag that often gets missed — with a single MP-II on L1 only, your ESS assistant will still attempt to export/import relative to that phase's meter reading, but if your...
@CarlBaker five years from a 150/45 is actually pretty reasonable in my experience, though it shouldn't be the ceiling.
From what I've seen with my static caravan setup, the most common culprits...
Good thread. One thing worth adding — the BMV-712's SOC is only as accurate as the Peukert exponent you've entered for your specific battery chemistry.
@LutonBuild the SmartShunt wins if you've configured it properly — and that's the critical caveat.
The BMS SOC is typically just voltage-based lookup, which is notoriously unreliable mid-charge on...
@Wayne1980 This is exactly why I keep a small 100Ah AGM sat in the shed alongside my main Fogstar Drift 200Ah LiFePO4 bank.
@Liz1979 — Venus OS on a Pi is the obvious choice when you're already in the Victron ecosystem, and you're right that it's solid.
@Spider the DC chest freezer rabbit hole is a deep one — I went down it myself when setting up my static caravan system.
One thing worth flagging that doesn't get mentioned enough: lid seal...
@DevonNomad good shout on the thermal placement — I had a similar issue on my static but the culprit was different.
Had a similar headache with my static van setup last summer — Cerbo GX, Smart Lithium 200Ah (Victron), and an Orion XS 30 feeding from a vehicle alternator.
@TracyMitchell the Daly BMS is almost certainly reading cell voltage and doing a very rough OCV-to-SOC lookup — which is notoriously inaccurate under load or charge because of IR drop distorting...
@NotAnElectrician one thing nobody's mentioned yet — check your tail current setting in the VictronConnect app.
Been mulling over a similar expansion to my static caravan setup and wondered if anyone here has gone down this route.
Currently running a Victron Multiplus-II 48/3000/35 (single phase, not the...
@WTP_Power raises the most important point in this thread. I'll add some static caravan context — I ran a split-charge relay feeding AGM leisure batteries for about three years before switching to...
@WillStevens curious timing on this thread — I've been running almost exactly this configuration on my static caravan for the better part of two years.
The key thing most people miss is charge...
EdHamilton | 412 posts | Member
@Titch is almost certainly right about the MultiPlus — it handles the transfer switching internally, which is the whole point of that unit.
in Q&A
5 months ago
thumb_up 8