@RetiredPlumber raises the point I was going to make about DC sag — but I'd go further and say log it properly rather than just checking.
@SparkySparky yep, and this is exactly why I ended up going full off-grid with the shepherd's hut rather than keeping a grid backup "just in case." The standing charge arithmetic just...
Been wrestling with something similar on a smaller scale in my shepherd's hut setup, so this caught my eye.
Had a mate recently trying to integrate a single-phase AC PV inverter into a 3-phase...
@Cleggy capacity testing is the only honest answer here — slap a proper load on it and log the discharge.
@ExTrucker I'm coming at this from a tiny house / cabin angle rather than a van, but the same physics applies — short runs in winter are basically useless for charging.
Worth checking your battery temperature sensor if you've got one wired in — mine was giving daft readings and the MPPT was pulling back absorption voltage thinking the battery was roasting when it...
Yeah @MarineVicky your post got truncated so we're all guessing here, but assuming it's a standard 100W panel (Renogy or similar), voltage drop on the cable run is the first thing I'd check before...
@GemmaWood I'd be a bit wary of assuming the optimiser is actually getting this right. In theory yes, it's arbitraging export vs cheap-rate charging, but the model relies on accurate price...
@OffGridDawn curious what absorption voltage you've landed on — there's a lot of conflicting info out there depending on whether your cells are EVE, CATL etc.
On my shepherd's hut build I use a...
@GrumpyWanderer had this exact situation on my shepherd's hut build — genuinely thought I'd killed a brand new Multiplus 12/3000.
What actually saved it: holding the rocker switch on the unit...
Been getting low temp cutoffs on my JK BMS pretty much every morning this week. Shepherd's hut isn't the best insulated and the battery compartment is in a ventilated box under the floor —...
@EcoFlow_Gal depends what you're optimising for, doesn't it.
For my shepherd's hut setup I went Victron SmartSolar 100/30 and yeah, it cost more than the Renogy equivalent.
ExPostie | 847 posts | Array
@Chopper same issue with my shepherd's hut setup. I kept the grid connection "just in case" for about 18 months and genuinely questioned whether it was worth...
@MoorKev I had a similar experience with my shepherd's hut setup — binned a cheap PWM after one winter and moved to a Victron SmartSolar MPPT.
@PanelGraham is right, but I'd add — even if you're thinking of the Victron Blue Smart IP67 or similar shore power unit, I'd be cautious about charging the starter battery while cranking.