@WheresMeWires31 those numbers are almost certainly peak/surge ratings being passed off as continuous.
@LazyBodger worth knowing the AUX input only does one thing at a time — you configure it in the VictronConnect app under SmartShunt settings as either midpoint voltage, starter battery voltage, or...
Macca64 | 1,203 posts | Array
@QMC_Camper fair point on the hybrid vs true off-grid distinction. My shepherd's hut runs purely on a 400Ah Fogstar lithium bank with 600W of Renogy panels and a...
@RetiredElectrician ran into almost exactly this with a Fogstar-adjacent BMS on my shepherd's hut build — RV-C enumeration going silent after a firmware bump is deeply frustrating when you're...
Had this exact issue with my shepherd's hut setup last winter. Multiplus II 24/3000 was dropping to float after maybe 40 minutes of absorption when the batteries were nowhere near properly topped...
Macca64 | 📍 Array | ⚡ Shepherd's Hut Build
Done exactly the same thing during my hut build — shunt wedged behind the battery bank, PUK code facing the wall, naturally.
@DustyCaptain @MarineGeoff — seconding the curtains but I'd add: fit a pelmet box above each one. Stops the convection loop where cold air falls off the glass and undercuts the curtain entirely.
Bit of a tangent from the solar controllers subforum but feels relevant enough — has anyone successfully got a conventional (non-inverter) generator syncing cleanly with a Quattro 48/8000?
Running...
Completely agree with both of you — and I'll add that the floor is where shepherd's huts lose a disproportionate amount of heat relative to the surface area involved.
On mine I went with 100mm...
Been thinking about this a lot recently after reading about someone stateside running a similar-style build on a converted coach — twin Multiplus II 5kVAs feeding a 240V split-phase panel, which...
@DalesCruiser — almost identical setup to mine in the shepherd's hut, so I've been through exactly this.
The key thing that caught me out was that without a shared battery sense wire between the...
Really important point that's been glossed over here — your BMS will aggressively disconnect under high charge current if the cells hit absorption voltage, and that sudden open-circuit dumps the...
Mid-way through wiring up my off-grid shepherd's hut and trying to nail down the DC-DC charger setup.
@BatterySam worth double-checking your actual panel Voc against your controller's input limits before adding more panels down the line.
@RhysLee78 one thing nobody's mentioned yet — check whether another device (tablet, old phone, laptop with VictronConnect) is already paired to the MPPT.
in Q&A
5 months ago
thumb_up 5