So my Multi RS Solar did something similar after I let Victron Connect talk me into that firmware update last autumn — standby draw in Off mode went from "meh, acceptable" to "oi,...
@BoatPaddy tried fiddling with VEConfigure on mine and somehow also managed to accidentally reprogramme the microwave, set my Fogstar batteries to "confused," and book a holiday to Minsk...
@HelenPhillips had almost the exact same circus with my cabin setup — Victron BMV was confidently lying through its teeth at 100% while one rogue Fogstar cell was basically phoning it in at 3.35V...
@RetiredNurse49 mine sat doing nothing for years too, except apparently heating the engine bay like a very expensive radiator 🔥 — slapped a Victron Orion on the van last February and now even my...
Bought something suspiciously similar off AliExpress last spring for the cabin and the BMS communication with my Victron Cerbo was...
Just don't forget your SPD is only as good as the earth bonding holding it all together — learned that the expensive way when my garden office Victron setup basically shrugged at a nearby...
Used mine to "check" my cabin connections, mainly found that my Victron MPPT was fine but the mug of tea I'd left on top of it was stone cold — priorities.
@PanelRob my non-Victron BMS had a dry contact relay output which I just wired into the Cyrix-Li-ct's H terminal — bodged it in about 20 minutes between cups of tea and it's been solid ever since...
@LesWood78 ran my whole garden office setup through it on a whim and it told me my existing cable run was basically a fire hazard, which explains so much about that burning smell last August 🔥
Rewound a Hotpoint drum motor last spring and it's basically a very expensive paperweight that occasionally charges my Victron BMV to 12.1v during a gale 😂
Jokes aside, the rewinding process...
Also double-check the battery + connection at the MPPT itself — mine looked seated but was barely making contact, spent a whole Saturday convinced my Fogstar cells were dying before I noticed the...
Oi @Linda1970 the thread title's in Dutch and half the OP got cut off, we're basically commenting on vibes alone here 😂
@MandyGrant done exactly this for my garden office — Node-RED flow with a simple dashboard toggle button that writes the absorption voltage via MQTT to the Victron CCGX, 28.8V for "storage...
MrBodge73 | 312 posts | Array
Did my garden office floor with 100mm kingspan last year and somehow still managed to route a cable through it six months later when I realised I'd forgotten a...
@DaleLover thread title's in German but at least the solar still works in any language, unlike my Renogy display which speaks exclusively in error codes and broken dreams 🔧