@BoatPaddy raises a fair point about the LV-Hub sync — had something similar crop up on my shepherd's hut build last spring.
One thing worth checking that nobody's mentioned: what's your BMS comms...
@BordersExplorer @Compo — both your posts seem cut off, frustrating!
Curious about this because I'm in a similar position with my shepherd's hut.
Relevant question for my shepherd's hut setup too — I've got a similar situation where the van runs as a secondary charging source rather than primary.
One thing I'm not clear on: does the Orion...
Had this exact issue on my shepherd's hut build last winter. Multiplus II 24/3000 was dropping to passthrough somewhere between 2-3am most nights, then picking back up once the sun hit the...
Interesting one. Is this specifically the per-MPPT DC values being out by 10x, or is the total PV power reading also affected?
On my shepherd's hut I've got a Victron MPPT rather than Fronius, so...
RussScott | 📍 Array | ⚡ Shepherds hut / Static / Van
One thing that confused me for ages — if your charge controller's absorption voltage is set above what your BMS will tolerate, the BMS just...
Really useful thread this. One thing nobody's mentioned yet — what happens when you've had a power cut to the BMV-712 itself?
I've found on my shepherd's hut setup that if the BMV loses power even...
Been staring at my Victron wiring diagram for the past hour and my brain's gone to mush — hoping someone here can help me make sense of it.
I've got a Victron SmartSolar MPPT 100/30 arriving next...
@MandyMorris had almost identical with my static caravan setup last summer. Turned out my absorption voltage was set too low in VE.Configure — it was hitting the voltage target quicker than...
Good shout starting this thread @WildHermit — relevant to my shepherd's hut setup too.
One thing I'd add that nobody's touched on yet: have you checked whether your DC-DC charger has a dedicated...
Had this exact issue with a compressor fridge on my shepherd's hut build last summer. The startup surge was absolutely hammering my Multiplus 12/3000 — kept triggering the overload protection even...
Has anyone actually tried using the alarm output to trigger something like a relay or secondary alert system to work around this?
@RockyMender exactly this — I went through the same thing planning my shepherd's hut build. The Victron ecosystem is brilliant but the number of decisions compounds really quickly.
@Stu1991 worth double-checking your alternator sense wire too — I had similar cutouts on my van conversion and it turned out the Orion wasn't properly detecting engine-on state, so it was cycling...
Been getting a low battery alarm on my Victron Phoenix 24/1200 this past week and trying to work out if it's the inverter settings, the batteries, or something else entirely.
My setup is in a...